Can I price grind and seal and full polish on the same job?

Yes. Measure each area on its own layer, such as the living areas polished and the garage ground and sealed, so the totals for each finish stay separate.

How do I price edge grinding?

Run the Perimeter tool around the walls and fixed joinery. Edges are slower to grind than the open floor, so the length lets you price them at their own rate.

Can I measure joints and cracks to fill?

Yes. Trace saw cuts, control joints and cracks with the Measure tool to get the total length to fill before you grind.

MetreMate for Polished Concrete Installers

Measure polished concrete floor areas from plans

Measure polished and grind and seal floors from PDF plans, price grinding, edges and joint filling, and keep each finish level separate.

Try MetreMate, it's free See how it works

No credit card needed. Free plan to start, works on Windows and Mac.

Why polished concrete installers choose MetreMate

Polished concrete installers use MetreMate to measure slabs straight from the plans before the first grind. Trace each floor with the Area tool, run the Perimeter tool for edge grinding along the walls, measure joints and cracks to fill, and keep grind and seal, full polish and each aggregate exposure on its own layer, so every finish is priced at its own rate. It runs in your browser, so there is nothing to print and nothing to install.

See how MetreMate compares

Quote in minutes, not hours

Set the scale once and measure straight off the PDF. Your first measurement takes under 90 seconds, and it's free to start.

Try MetreMate, it's free

No credit card needed

The slow way, or the smart way

What changes when polished concrete installers measure in MetreMate instead of off a printout.

Without MetreMate

Measuring slabs on site before every price
Underpricing edge grinding and joint filling
Mixing up finish levels across one job

With MetreMate

Area tool for grinding and polishing areas
Perimeter tool for edge grinding
Measure tool for joints, cracks and saw cuts
Count tool for floor wastes and penetrations
Layers Manager to separate finish levels and exposures
Pencil tool for freehand mark-ups, and to add your initials or signature by hand

500+

Tradies using MetreMate

50,000+

Measurements taken

90 seconds

Average time to measure

Everything you can measure off the plan

Set the scale once, then pull the quantities polished concrete installers actually quote on.

Lengths & lineal metres

Any distance, edge, or run measured straight off the plan.

Areas in m²

Trace rooms, slabs, and zones for instant square metres.

Perimeters

Boundary and edge runs totalled for you, no maths.

Counts

Tap to count fixtures, fittings, and symbols with live totals.

Step by step

How polished concrete installers use MetreMate

1
Floor area takeoff
Use the Area tool to measure every floor to be ground and polished, and leave out areas under joinery or fixed fittings.
2
Edges and joints
Run the Perimeter tool for edge grinding along walls, and the Measure tool for saw cuts, cracks and joints to fill.
3
Finish levels
Keep grind and seal, full polish and each aggregate exposure on its own layer, so every finish is priced at its own rate.

Read our how-to guides