Can I measure gutter and downpipe runs from a plan?

Yes. Measure eaves gutter, box gutter, and downpipe lengths directly on the roof plan, with snapping to follow the roof edges accurately.

Can I take off flashing?

Measure ridge, valley, and wall flashing lengths from the plan so your material order for capping and flashing matches the job.

Can I estimate roof drainage from the area?

Measure the roof plan area and apply the pitch factor to size gutters and downpipes, so drainage is quoted on real numbers rather than a rough look.

How do I keep eaves gutter, box gutter, and downpipes separate?

Put each element on its own layer as you measure, so eaves gutter, box gutter, and downpipe lengths total on their own. That gives you a clean linear metre figure for each to order and price against.

How accurate is measuring flashing off a roof plan?

As accurate as the drawing. With the scale set and snapping following the roof edges, your ridge, valley, and wall flashing lengths match the plan, so you order the right run of capping without a ladder.

Can I count downpipes and rainwater heads?

Yes. Use the Count tool to tally downpipes, rainwater heads, and outlets across the plan while you measure the gutter runs, so the fittings are counted alongside the linear metres for a complete quote.

MetreMate for Guttering & Metal Roofing Installers

Measure roof drainage and flashing from plans

Measure gutters, fascia, ridges, and valleys, count downpipes and rainheads, and work out steel roof sheets and cladding without climbing a ladder.

Try MetreMate, it's free See how it works

No credit card needed. Free plan to start, works on Windows and Mac.

Guttering & Metal Roofing Installers at work

Under 90s to your first measurement

Why guttering & metal roofing installers choose MetreMate

Guttering and metal roofing installers use MetreMate to measure gutters, fascia, ridges, valleys, and roof areas from plans, without climbing a ladder to quote. Run the Perimeter tool for gutters, fascia, ridges, and valleys, count downpipes and rainheads, and use the Area tool for steel roof sheets and metal cladding. It runs in your browser, so you can price roof plumbing from the drawing.

See how MetreMate compares

Quote in minutes, not hours

Set the scale once and measure straight off the PDF. Your first measurement takes under 90 seconds, and it's free to start.

Try MetreMate, it's free

No credit card needed

The slow way, or the smart way

What changes when guttering & metal roofing installers measure in MetreMate instead of off a printout.

Without MetreMate

Measuring gutter and downpipe runs on site for every quote
Estimating flashing lengths from plan views
Material waste from rough measurements

With MetreMate

Perimeter tool for gutters, fascia, ridges, and valleys
Count tool for downpipes and rainheads
Area tool for steel roof sheets and metal cladding
Snapping for roof edges
Pencil tool for freehand mark-ups, and to add your initials or signature by hand

Everything you can measure off the plan

Set the scale once, then pull the quantities guttering & metal roofing installers actually quote on.

Lengths in metres

Any wall, run or edge measured straight off the plan.

Areas in square metres

Trace rooms, slabs and roofs for instant areas in m².

Perimeters

Boundary and edge runs totalled for you, no maths.

Counts

Tap to count fixtures, fittings, and symbols with live totals.

Step by step

How guttering & metal roofing installers use MetreMate

1
Gutters, fascia, ridges, and valleys
Use the Perimeter tool to estimate gutters, fascia, ridges, valleys, and flashings.
2
Downpipes and rainheads
Count downpipes and rainheads with the Count tool.
3
Steel roof sheets and cladding
Use the Area tool to work out how many steel roof sheets you need, including metal cladding.

Read our how-to guides